Gree 13-04686 사용 설명서 - 페이지 5
{카테고리_이름} Gree 13-04686에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gree 13-04686 20 페이지.
페이지 인쇄
3. Choose the proper window location.
Choose a window that allows the cooled air
to flow freely and directly into room(s) you
wish to cool. Remember, it is difficult to
move air around corners. Also, choose a
window that is within 6 feet of an electrical
outlet. (See Meeting Electrical
Requirements/Receptacle wiring needs.)
Do not use an extension cord.
Installing Unit in a Sliding Window
1. Attach support brace to platform as
shown. Use adjustment bolt and hex flange
nut to complete assembly. Choose slot and
adjustment bolt hole locations that will cre-
ate a 45 degree angle between platform and
support brace. Try assembly in the window
to determine if platform will rest properly,
and allow proper slope (3/16-inch lower on
outside).
NOTE: If you are planning to use a siding
protection board (see Step 5) on the outside
of your house, hold board in place when
testing assembly in window.
2. Measure, and lightly mark a line 8-11/16
inches from window jamb.
NOTE: If any sash stop protrudes more than
1 inch from the side window jambs, the 8-
11/16-inch measurement must be increased
accordingly. Screen and storm window
frames may also require adjustments to the
measurement.
3. Center platform assembly on the line
with inside platform tab pressed against
inside edge of window track. Using the
holes in the platform as a guide, mark and
drill two 9/64-inch diameter holes. Drill
holes in either track or stool.
(continued)
6 foot
power cord
reach
1/4" (6mm) HEX
FLANGE NUT
8 11/ 16 inches
Alternate
screw
location
(depending on
the stool depth)
Window track
AVERTISSEMENT
Property Damage Hazard-Failure to adhere
to the following precaution could result in
damage to window or air conditioner.
Be sure wood stool or window track is
securely attached to the building construc-
tion. Use longer screws in sub-framing if
necessary.
5
Platform Assembly
Platform tab
Window seal