Automation Dr. Nix QNix 1500 사용 설명서 - 페이지 7
{카테고리_이름} Automation Dr. Nix QNix 1500에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Automation Dr. Nix QNix 1500 12 페이지. Coating thickness gauge
페이지 인쇄
a double "Beep" and the value will be displayed. After approx.
1 second, the display changes and gives you the number of
the measurements just taken. Both readings will be displayed
alternately, e.g. the display will show N 14 (number of
measurement) and 124 μm (last measured value).
To leave the Memory Mode, push both slides simultaneously
and very shortly.
Do not hold.
The built-in memory can store up to 3900 measurements. In
case the memory capacity is limited, the display will show
"END" for approx. 6 seconds. After this, you will see the last
measured value alternating with the number of this
measurement.
If no measurements are taken within 30 seconds, the gauge
will switch off. The gauge will automatically return to Normal
Mode when started again.
Block Segmentation within the Memory
Mode
It is possible to store the measuring values in different blocks,
in order to distinguish the different tasks. To set up a new
block, e.g. Block 2, push both slides simultaneously forward
and hold them until you see the display changing. Let the
slides go. Accompanied by a "Beep", the display will show
"bloc" alternating with b002. Now you have created a new
block and all following measurements will be stored in Block 2.
Other blocks can be created using the same procedure.
The sizes of the blocks may vary as they are determined by
the user only. Within the total capacity of the memory up to
999 blocks can be built. If the memory runs out of space, the
information "End" will be shown.
Display of Mean, Maximum and Minimum
Values
Additionally, the gauge can display the mean, maximum and
minimum value of the measurements taken in the presently
used block, if the gauge is switched on and working in the
Memory Mode. Push one of the slides for approx. 1 second
7