DynaLock 2280 설치 지침

{카테고리_이름} DynaLock 2280에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. DynaLock 2280 8 페이지. Electromagnetic lock
DynaLock 2280에 대해서도 마찬가지입니다: 설치 매뉴얼 (8 페이지), 설치 지침 매뉴얼 (12 페이지)

페이지 인쇄

705 Emmett Street P.O. Box 9470 Forestville, CT 06011-9470 Phone (860)582-4761 Fax (860)585-0338

Familiarize yourself with the door and frame conditions prior to installation. The lock must rigidly mount to the

underside of the frame header. The armature is designed to pivot slightly to compensate for reasonable

misalignment.

Armature mounting hardware is supplied for a standard 1-3/4" thick door. For thicker doors order the following

special armature hardware kits:

Part #300687 for 2" thick doors.

Part #300688 for 2-1/4" thick doors.

HANDLING

The Electromagnetic lock and armature are

ruggedly constructed and designed to provide

years of trouble-free service. Care must be taken

during installation and use to keep the lock face

and armature face free from dirt, rust, burrs, paint,

or any other obstruction which may interfere with

the lock and armature making good contact.

The illustrations below depict typical installations of the Model #2511 Lock on single-outswing doors. The lock

assembly must be surface mounted to the underside of the frame header with the armature affixed to the inside

face of the door as shown.

LHRB DOOR

DynaLock Corp.

Electric Security Hardware

MOUNTING INSTRUCTIONS

SERIES 2511 ELECTROMAGNETIC LOCK

FOR A SINGLE OUTSWING DOOR

PLEASE READ BEFORE INSTALLATION

GENERAL MOUNTING INFORMATION

The lock assembly and door armature have been

plated for maximum corrosion resistance. To

ensure peak performance clean the lock and

armature faces with a mild detergent and a clean,

soft cloth, then apply a light coat of WD40 to protect

these surfaces. This need only be done when dirt

build-up is noticed.

LOCK

ASSEMBLY

ARMATURE

page 1

MAINTENANCE

RHRB DOOR