DynaLock 2013 설치 지침 - 페이지 2
{카테고리_이름} DynaLock 2013에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. DynaLock 2013 4 페이지. Electromagnetic lock
페이지 인쇄1.
SURVEY THE INSTALLATION
Inspect the gate and determine if supplemental brackets and/or special mounting hardware will be required for
installation ( refer to page 1 "General Mounting Information" ). If you are using the optional Dynalock Gate Lock
Bracket refer to the instructions furnished with the bracket for specific installation information. Fabricate/procure
custom bracket(s), hardware, and/or attachments as necessary.
2.
PREPARE THE GATE POST FOR MOUNTING THE GATE LOCK ASSEMBLY
Determine the desired location for mounting the 2013 Gate Lock assembly on the gate post. Orient the end of the lock
with the 3/4" threaded conduit fitting relative to the location of electrical hook-up wiring.
If you are mounting the lock assembly directly to the post, locate, mark, and drill four (4) 9/64" dia. mounting screw
holes as per Fig. "A" on page 3. If using an intermediate bracket to affix the lock assembly to the post, prep the
mounting screw holes accordingly.
3.
PREPARE THE GATE FOR ARMATURE MOUNTING
From the three illustrations below, select the one that resembles your gate type and follow the instructions for drilling
the armature mounting screw hole. Drill two (2) 1/4" dia. holes 9/16" deep at the anti-spin pin locations
"B" on page 3 ).
If an intermediate bracket will be used to affix the armature to the gate, prep the amature mounting and anti-spin pin
holes on the bracket accordingly.
4.
MOUNTING THE ARMATURE
Locate the two 3/16" dia.anti-spin pins from the hardware kit. Place the armature face-down on a soft surface ( i.e. the
shipping carton ) and drive the anti-spin pins into the holes provided. Refer to the illustrations below to select the
correct mounting hardware and mount the armature. Firmly tighten the armature mounting screw with a 3/16" hex
wrench.
Failure to propery secure the armature to the gate could result in serious injury or possible security
breach.
1-3/4"
D O O R
SPACER
SEX
NUT
21/32"
HOLLOW TUBE
GATE
Drill an 11/32" diameter hole
through gate. From sex nut
side only enlarge the 11/32"
hole to 21/32" diameter.
2013 MANUAL - FORM 2013-001
MOUNTING PREPARATION
STEEL WASHER
ARMATURE
1"
ARMATURE
SCREW
SEX
NUT
1/2"
ARMATURE
SPACER
RUBBER
WASHER
SOLID CORE
GATE
Drill an 11/32" diameter hole
through gate. From sex nut
side only drill 1/2" diameter
hole to 1" depth.
STEEL WASHER
ARMATURE
ARMATURE
SCREW
ARMATURE
SPACER
RUBBER
WASHER
page 2
5/16"-18 THREAD
REINFORCED
TUBE GATE
Drill an 17/64" diameter hole
and tap for 5/16"-18 thread.
( see Fig.
STEEL WASHER
ARMATURE
ARMATURE
SCREW
ARMATURE
SPACER
RUBBER
WASHER
02/03