Hide-A-Hose HPHS5000W 설치 매뉴얼 - 페이지 8

{카테고리_이름} Hide-A-Hose HPHS5000W에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Hide-A-Hose HPHS5000W 13 페이지.

When using the Rapid Flex hose,

we recommend installation of a

reducer in the pipe run, before the

first standard fitting. This prevents

the possibility of the hose

getting stuck in a tight fitting, if

it stretches when retracted. See

diagram below for positioning.

Low Voltage Wire

Run low voltage wire to each inlet, just as you would with a standard

central vacuum install.

It is a good idea to test the system by retracting a hose before the walls are

sheetrocked.

Since the doors are needed to seal the system, a hand ball can be placed

over each valve opening that is not being tested to seal the system. In an

up orientation, you will need to tape the hand ball in place.

Using a portable source of vacuum, check the system for sealed vacuum.

Sealed vacuum at the valve should not vary more than three to five inches

from the sealed vacuum at the power unit.

- 6 -

Hose

End Cap

Hose

Pipe

Reducer

positioned

before first

standard fitting.

HS5000 INSTALLATION GUIDE

Coupler

Reducer

Hose

ends

Pipe