Gainsborough SD8 그림으로 보는 피팅 지침 - 페이지 2

{카테고리_이름} Gainsborough SD8에 대한 그림으로 보는 피팅 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Gainsborough SD8 2 페이지. For sliding screen doors

페이지 인쇄

Fit the strike plate into the lock.

Close the door until the strike plate reaches the receiving channel.

Mark the position of the strike plate on the channel.

Open the door and install the strike plate with two #10 x 13mm pan head screws.

Note: Place the screws in the centre of the slots to allow for adjustment.

Test that the strike plate engages the lock correctly and adjust if necessary.

SD8 - CARE & MAINTENANCE

Installation

The product must be installed according to the instructions included in the product packaging and the

door should be apertured according to the door "cut-out" dimensions and tolerances shown.

Prior to fitting ensure that:

· Doors stored on site are stored in a clean dry area free from cement, lime, paint, acid etc.

During fitting of the lock ensure that :

· No metal swarf or other contaminants enter the lock body.

· The fixing screws do not damage the product finish.

After installation of the door ensure that:

· The door is correctly adjusted with the correct clearances.

· The lock engages the strike plate correctly.

· The door is protected from building fall-out such as wet plaster, mortar, paint and welding splatter.

If the door becomes contaminated:

· Do not paint the lock body or faceplate.

· Remove wet plaster, cement, mortar and other droppings immediately, using ample clean water and a sponge or rag, to avoid permanent

staining or scratching of the product finish. If removal is delayed and scraping becomes necessary the surface finish may suffer.

Maintenance

Annually inspect the door to confirm that the door operates with the correct clearances, closes and opens without obstruction and confirm that the lock beak

slides easily into the strike plate aperture when the door is closed - adjust the door if necessary.

Annually check that when the door is closed, the lock can be locked by key and by the snib lever.

Quarterly wipe the strike plates with a soapy rag to remove built up debris and to lubricate the strike plate.

NB : The lock assembly has been lubricated for life, and should not be disassembled by the user.

Cleaning Powder Coatings

Every six months, powder coated surfaces should be cleaned to protect the finish. However, in areas where pollutants are more prevalent, especially in

coastal or industrial regions, cleaning should be carried out every two to three months.

To clean the powder coated surface:

1. Carefully remove any loose deposits with a wet sponge.

2. Use a soft brush (non abrasive) or cloth and a mild household detergent solution to remove dust, salt and other deposits. Do not use steel

wool, scrapers, scouring liquids or powders to remove deposits as these permanently scratch the coating surface.

3. Rinse off with clean fresh water.

Cleaning Chrome, Satin Chrome, Gold and Brass Finishes

Plated finishes are susceptible to tarnishing if they come into contact with moisture, wet paint, or water vapour. All plated finishes should be coated with a

non-abrasive furniture or car wax immediately after installation. Plated finishes should be regularly wiped with a non-abrasive furniture or car wax, taking care not

to scratch any protective finishes that are employed to protect the surface and prevent tarnishing.

SD8 - MAINTENANCE LOG

In order to protect your warranty, record all maintenance activity in the following log:

Address of Building :

Name of Door:

Date

Activity

Strike Plate Installation

strike plate

receiving channel

Signed

Austral Lock

31-33 Alfred Street,

VIC 3130, Australia

www.ausloc.com

GAINSBOROUGH

Hardware Industries Limited

Blackburn,

ph 13 14 18

fax 13 18 14

A division of