Dynamatic 4050 지침서
{카테고리_이름} Dynamatic 4050에 대한 지침서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynamatic 4050 13 페이지. With dancer position
Dynamatic 4050에 대해서도 마찬가지입니다: 지침서 (15 페이지), 지침서 (14 페이지), 지침서 (13 페이지)
페이지 인쇄
Instruction Sheet
IS-539-09
revised 2019
15-533-1009 Panel Mount 4000 (4.3 A Controller)
15-551-1009 Standard Enclosure 4000 (4.3 A Controller)
15-539-0009 Panel Mount 4050 (8 A Controller)
15-553-0009 Standard Enclosure 4050 (8 A Controller)
Model 4000 and 4050 with Auto Manual Tach Follower
Introduction
These instructions relate specifically to
the following Model 4000 and 4050
controllers which are assembled for
Speed Control with the Auto Manual Tach
Follower Modification.
Connection diagram, schematic diagram,
switch
programming,
connection, adjustment procedure and
recommended spare parts list for these
specific assemblies are contained in this
instruction
sheet.
Any
between these two controllers are clearly
noted.
Use instruction manual IM-130006-83-XX
with this instruction sheet for complete
installation, operation and maintenance
instructions.
Caution: Above ground potentials can be
hazardous. Always disconnect electrical
power before working on the controller.
*Heat sink assembly, HS1, and its wiring
apply only to the Model 4050 controllers.
These parts are not supplied on the Model
4000 controllers. The parts are mounted
on the 15-530-5 main 4000 board.
1
plug
wiring
differences
Drive Source International/Dynamatic
7900 Durand Ave Bldg 3 Sturtevant, WI 53177
800-548-2169 •
www.Dynamatic.com