DB Drive Okur A6 2800.1D 사용자 설명서 - 페이지 7

{카테고리_이름} DB Drive Okur A6 2800.1D에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DB Drive Okur A6 2800.1D 9 페이지.

( A6 800.4, A6 1200.4, A6 1600.4 )

network that allows you to select the crossover mode (Highpass—Full Range) and desired

crossover point for channels 1 and 2. Channels 3 and 4 allow you to select between a

Highpass 12db slope, a 12db Stereo Lowpass / Bandpass slope and a mono 24db Lowpass /

Bandpass slope. For example if you wish to drive a pair of subwoofers on channels 3 and 4

out the high frequencies with a 24db slope. You will then need to adjust the Lowpass

control to the desired frequency setting (make sure to have the Highpass control set to

switch to LP/BP stereo. Once the LP/BP stereo switch setting is selected you will use both

any unwanted low frequencies with a 12db slope.

( A6 1600.1D, A6 1900.1D, A6 2800.1D )

The A6 1600.1D, A6 1900.1D and A6 2800.1D are equipped with a variable 24db slope

feature a variable Bass Boost EQ is set at 45Hz. In some subwoofer enclosure installations it

may necessary to use the Phase Shift feature. The Phase Shift button sets the Subwoofer

subwoofer enclosure. All A6 mono amps are also equipped with Multi-Linking technology.

When using a single A6 mono amp set the Master / Slave switch to the Master position.

the slave setting the front panel controls become inoperative. All adjustments for both

Multi-Link

Diagram

RCA input

Select Master

Master Amp

Master controls

Slave Amp

Slave controls are void

Select Slave

2 ohm minimum