89 North PhotoFluor II 교체 매뉴얼 - 페이지 4

{카테고리_이름} 89 North PhotoFluor II에 대한 교체 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 89 North PhotoFluor II 8 페이지. Lamp replacement

And now . . . Replacing the Lamp

The PhotoFluor II and PhotoFluor II NIR 200 Watt lamps must be

properly installed to allow ignition, proper cooling and alignment to

assure the longevity of the bulb. Your unit is shipped with the lamp

installed. When removing the lamp, take care not to touch the

reflector surface (inside or outside) as finger oils or

contaminants will harm the bulb. The lamp's connector must be

properly installed.

After installing the bulb and the unit is turned on, you must reset the

lamp counter.

The bulb is pictured below:

Lamp Power Cable

Rev B

Figure 1: Lamp

The lamp should only be handled wearing gloves

and suitable eye protection.

Reflector