Dynamax AVRD 3.2 설치 및 운영 매뉴얼 - 페이지 6
{카테고리_이름} Dynamax AVRD 3.2에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynamax AVRD 3.2 12 페이지. Voltage regulator
페이지 인쇄SHDN LINE (Power Down)
SHDN line input for power down
Output when shut down
SHDN line off state (Normal/output ON)
SHDN line drain current
Temperature Specifications
Operating Temp
Junction Temp
Storage Temp
Protection
Primary: Current limit
Secondary: Fuse
Mechanical
Enclosure
Weight
Dimensions - Enclosure LxWxD
Dimensions - Overall
2.0 Installation and Operation
2.1 Installation
Provided that your system came with a regulator installed, there is nothing more to do but
skip to the next section on operation. Refer to data logger manual for operating instructions
specific to the logger. For custom, upgrades, or all other kits this section describes the tools,
recommended parts, and assembly.
2.1.1 List of Tools required to install AVRD
• 11/64" drill bit
• Electric drill
• Philips screw driver
• 5/16 Hex nut driver
• Wire cutter
• Wire stripper
• Flat blade screw driver
• Phillips head screwdriver
In addition required are wires for connecting AVRD input terminals to the power source (battery/
solar panel/ AC outlet adapter) and AVRD output terminals to the sensor heater elements.
>0.8 V (or open circuit/no connection)
125 C (Tj=Ta+pd. 130 C/W)
-65 ro 150 C
In circuit current limit
15 A in-line fuse (5 x 20 mm)
Aluminum, Anodized
1.5 lb (680 g)
4-1/4" x 3-1/4" x 1-5/32"
108 x 83 x 29 mm
5-1/4" x 4-1/16" x 1-5/32"
133 x 103 x 29 mm
5
<0.8 V
0 V
1 mA
-40 to 85 C