Hideaway Beds Beta Bed Double 조립 지침 매뉴얼 - 페이지 11
{카테고리_이름} Hideaway Beds Beta Bed Double에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Hideaway Beds Beta Bed Double 20 페이지. Wallbed frame and cabinet system
페이지 인쇄STEP 4: Assemble the Bed Cabinet (vertical orientation)
Be sure that all Bed Cabinet components are cleaned, sanded, and finished at
this time.
Bed Face Panels and Rails should not be finished at this time. Finishing will
inhibit glue bond to Bed Face. Finish after assembly.
For easier final wall mount you should assemble bed cabinet in the room where
it will be used.
Be sure Lift Mechanisms are securely installed.
1.
Locate the mounting position of the Headboard, marking the left and right Side
Panels 20" (508mm) from the floor and 3" (76mm) in from the back edge of the
panels. Note from the Drawings 5 & 7 that this mounts the bottom edge of the head-
board out 3" (76) from the back or wall edge of the Side Panels. Use the 1"x1"x1 3/4"
(25x25x44mm) mounting brackets (2 each side). Be sure the top bracket is set low
enough not to protrude beyond the back of the cabinet. Use #8 x 3/4" Pan head
Screws. The Headboard location may vary slightly; just be sure it is secure and at the
approximate 3" (76mm) distance from the back edge.
2.
Use Angle Brackets to assemble the Bottom Rear Base and Bottom Kick in the
position shown in Drawings 5 & 7. Use two Angle Brackets on each end.
3.
Attach Top Panel as shown in Drawings 5 & 7. Be sure back edge of the Panel is
flush with back of Side Panels and 1 1/4" (32mm) down from top of Side Panels to be
flush with the bottom edge of the Top Facia. The Top Facia will cover the front edge of
the Top Panel.
Left Side Panel
Bottom Rear Base
Top Facia
Head Board
Bottom Kick
Drawing 5.
Top Panel
1"x1"x1 3/4" (25x25x44mm)
Angle Brackets
Right Side
Panel
1"x1"x1 3/4" (25x25x44mm)
Angle Brackets
11.