Hideaway Beds Foldaway 시공 매뉴얼 - 페이지 2

{카테고리_이름} Hideaway Beds Foldaway에 대한 시공 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Hideaway Beds Foldaway 10 페이지. Bed frame and cabinet cm-vobt-part./90/140x190-jw062

페이지 인쇄

Introduction

The following notes are intended as a guide for the construction of cabinets to mount and accommodate

the Foldaway (CMVOBT) 90/140 bed frames and mechanisms. Due to the difference in cabinet making

styles and fitting techniques, it is suggested that a prototype cabinet is made using this guide, in order

to tailor these instructions to suit your individual requirements.

IMPORTANT: If packaging is damaged check bed frame for any damages and all components are present.

If any items are missing contact your retailer immediately. Under NO circumstances store/lay objects

under the bed or between the door and bed-frame when in the horizontal position, doing so will result

in damages to the door and bed frame.

Components List

1 X Bed frame (in 2 pieces)

2 X Bed frame joining bars (1 X additional on

double beds)

3 X Sub-frame joining bars

1 X Mattress support bar (2 X on double beds)

1 X Leg bar

2 X Leg ends – 'U' shape

Suggested Cabinet Dimensions



For cabinet dimensions see the attached drawings.



The cabinet should be made from 18mm thick panels



Cabinet widths are indicated on the attached drawings and obviously vary with bed size, but the

internal measurement must always be 64mm wider than the bed frame to accommodate

mechanisms and mountings.

Bed Mechanism & Cabinet Assembly

1. Assemble cabinet as shown on attached drawings. We recommend inset doors, but if your cabinet

is to have face fitting doors then either the lower corners of the doors or lower part of the

cabinet needs to be cut away to allow the head of the bed to swing into cabinet.

2. IMPORTANT: Always make sure that the cabinet is securely fastened to the wall and to adjoining

cabinets, if possible.

doors require additional side panels for extra strength if not attached to other cabinets.

3. Mount the doors of the cabinet onto the sub frame (the underside of the bed frame). In order to

position the doors on the CMVOBT system you must align them centrally in relation to the frame

with the bottom of the doors flush with the bottom of sub frame.

All wall bed and cabinet fixations must be regularly checked. Face fitted

2 X Bedding straps

2 X Mounting Plates + fixings

2 X Mechanisms

1 X Mechanism fixing kit

2 X Wall brackets

2 |

P a g e