Hideaway Beds Foldaway 시공 매뉴얼 - 페이지 9

{카테고리_이름} Hideaway Beds Foldaway에 대한 시공 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Hideaway Beds Foldaway 10 페이지. Bed frame and cabinet cm-vobt-part./90/140x190-jw062

페이지 인쇄

9 |

P a g e

Headboard Arrangement For An Integrated Cabinet

Please note headboard arrangement and fixings are not supplied.

The headboard arrangement is

intended as a guide based on our suggested cabinet depth. Headboard dimensions are noted below

(double dimensions in brackets).

All bed frames are supplied with mattress support bars (A) but these are to be disregarded where a

headboard will be in use – please retain the Allen bolts and nuts for re-use.

The bed frame will need to be held at the foot end in the horizontal position by another person whilst

attaching the headboard arrangement and the smaller panel (B) of the preassembled headboard is to be

bolted to the bed frame head therefore remove some of the slats at the head of the bed to allow better

access for this.

Suggested method

Place the headboard into the position shown (the angled cut at the back). Align the headboard (C) with

the cabinet sides with a 1 mm gap each side. Clamp the small panel (B) to the head of the bed-frame

so the bottom edge of the panel is in line with the bottom edge of the bed-frame. Drill through the

metal bed-frame and headboard panel with a 6 mm metal drill. Push the Allen bolts through the holes

and place a penny washer behind the headboard panel and tighten the 10 mm nut onto the back. Replace

the bedding slats and test to sure free movement when folding the bed.