Hideaway Beds SwingAway 조립 지침 매뉴얼 - 페이지 3

{카테고리_이름} Hideaway Beds SwingAway에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Hideaway Beds SwingAway 8 페이지. Bed
Hideaway Beds SwingAway에 대해서도 마찬가지입니다: 조립 지침 매뉴얼 (10 페이지)

페이지 인쇄

Instructions

1. Join the 2 x part bed frame 'A' & 'B' together using 'C' & 'D'. (fig 2)

2. Bolt the counterbalanced units 'E' & 'F' to the sub-frames 'H' & 'I' ensuring that 'H' is located

at the front and that the lug is on the left hand side. (fig 1)

3. Before tightening the nuts, connect the angled wall brackets 'G' to the top rear bolts on the sub-

frame 'I'. The brackets have two holes; the ones to be used are determined by the thickness of

the mattress i.e. the distance of the bed frame from the wall.

4. Bolt the mattress support 'J' to the bed frame.

5. Bolt the bed frame to the pivot arms of the counterbalanced units. ('E'&'F')

6. Join together the automatic leg bar 'K'& 'L' then attach to leg 'M' and the lug on frame 'H' using

the washer and split pin.

7. Screw pull handle 'N' to the crossbar of the legs.

8. Place the assembled bed and sub-frame in the preferred position in the room and mark out the

holes to be drilled in the wall and floor. Fix as appropriate.

9. Fix the sub-frame securely to the wall using the correct fixings to suit the wall and floor material.

10. With the bed in the horizontal position, place the mattress onto the frame and secure with

bedding straps. N.B. without the weight of the mattress the bed will try to return to its upright

position, so it is suggested to get somebody to hold the bed whilst you put the mattress on.

Important Safety Factors:



Due to the extremely reactive springs it is important that you always manually control the bed

by maintaining hand contact whilst in the ascent and decent position.



Do not remove the mattress whilst in the horizontal position unless the frame is being held by

another person.



If you are relocating the bed do not remove any of the fixings unless the bed is in the vertical

position.



Children are discouraged from being in the vicinity when being assembled, fitted and from

playing with the model either in the sleeping or stored position.



Care must be taken care when operating the bed, never lift the bed with anyone on the bed.



All wall beds and cabinets must be securely fixed to the wall and fixations regularly checked.

3 |

P a g e