AutomationDirect SureServo2 매뉴얼 - 페이지 11
{카테고리_이름} AutomationDirect SureServo2에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AutomationDirect SureServo2 18 페이지. 110/220 vac drives
AutomationDirect SureServo2에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (4 페이지)
페이지 인쇄
1) Any protective paint of the U-shape saddle EMC cable clamp and metal plate should be
removed in order to ensure good contact.
2) EMC cable clamp U-shape saddle
3) Well-grounded metal plate
2.8 - Selecting the regenerative resistor for dynamic breaking
When the direction of torque is different from the direction of rotation, the energy generated
returns to the servo drive from the load. This energy is turned into electricity in the capacitor
bank of the DC Bus and thus increases the voltage. When the voltage reaches a given value,
it is consumed by a regenerative resistor. Servo drives up to 3kW have a built-in regenerative
resistor. You can also use the external regenerative resistor if needed. See the table on the
following page for allowable external braking resistor values.
1) Moving direction of the object
2) Direction of torque
3) Regenerative energy
The built-in regenerative resistor in the SureServo2 is as follows:
SureServo2 User Manual – 1st Edition – 05/20/2021
Chapter 2: Installation
Page 2–11