Hideawaybeds alpha bed SBF 조립 지침 매뉴얼 - 페이지 9

{카테고리_이름} Hideawaybeds alpha bed SBF에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Hideawaybeds alpha bed SBF 18 페이지. Steel bed frame

STEP 3: Assemble the Bed Cabinet (Vertical Orientation)

If possible, the Bed Cabinet should be assembled in the room where it will be used.

Be sure Lift Mechanisms are securely installed.

Locate the mounting position of the headboard marking the left and right side panels

20" (508mm) from the floor and 3" (76mm) in from the back edge of the panels. Note

from Drawings 6 & 7 that this mounts the bottom edge of the headboard out 3"

(76mm) from the back or wall edge of the Side Panels. Use the 1"x1"x1 3/4"

(25x25x44mm) mounting brackets (2 each side). Be sure the top bracket is set low

enough not to protrude beyond the back of the cabinet. Use #8x3/4" (M4x19mm) Pan

head Screws. The Headboard location may vary slightly; just be sure it is secure and

at the approximate 3" (76mm) distance from the back edge.

Use Angle Brackets to assemble Bottom Rear Base and Bottom Kick in position

shown in Drawings 6 & 7. Use two Angle Brackets on each end.

Attach Top Panel as shown in Drawings 6 & 7. Be sure back edge of the Top Panel is

flush with back of Side Panels and 1 1/4" (32mm) down from the top of the Side

Panels so it is flush with the bottom edge of the Top Facia. The Top Facia will cover

the front edge of the Top Panel.

Top Facia

Left Side Panel

Head Board

Bottom Rear Base

Bottom Kick

Drawing 6.

Top Panel

1"x1"x1 3/4" (25x25x44mm)

Angle Brackets

Right Side

Panel

1"x1"x1 3/4" (25x25x44mm)

Angle Brackets