2gig Technologies Go!Control Panel 사용자 설명서 - 페이지 17
{카테고리_이름} 2gig Technologies Go!Control Panel에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 2gig Technologies Go!Control Panel 20 페이지.
페이지 인쇄Tap Away.
6
To arm the system, enter a user code if
your installer has turned off the system's
Quick Arming feature.
The system arms and shows the Exit
7
Delay counting down. When the Exit
Delay expires, the system is fully armed
in the Away mode.
NOTE: When the system is armed in
the Away mode, beeps sound
during the Exit Delay (faster beeps
during the last 10 seconds).
DISARMING THE SYSTEM
To stop the Control Panel from triggering
burglary alarms, the system needs to be
disarmed. Disarming turns off the burglary
detection part of the system for sensors that
are not 24‐hour sensors. Disarming also
stops any type of alarm in process.
Disarm the system from Stay mode before
exiting the premises. The system should be
disarmed from Away mode before or while
entering the premises. When disarming from
the Control Panel or wireless keypad, enter a
valid user code. A wireless key fob can also
be used to disarm the system. Entering a
user code is not required when disarming
with a wireless key fob.
An important feature of the Control Panel is
its ability to warn you if an alarm has
occurred while you were away. If an alarm
was triggered while the system was armed,
the alarm siren runs for a preset length of
time then stops. When you enter to disarm
the system, instead of sounding the normal
Entry Delay beeps, the Control Panel sounds
repeated fast beeps to warn you that an
alarm has occurred while you were away.
Use Extreme Caution! An intruder may
still be present inside the building! Wait
outside and use a Cell Phone to call law
enforcement for assistance.
Disarming from Stay Mode
Disarm the system from Stay mode before
exiting the premises.
At the Home screen, tap
1
Control.
At the Security screen or the Menu
2
screen, tap Disarm. This action displays
the Disarm Code screen.
The left side of the screen shows any
3
events that have occurred while the
system was armed.
Enter a valid user code to disarm the
4
system.
•
In case you tap the wrong key, the
•
Tap
the system at this time.
Copyright © 2015 Nortek Security & Control LLC
Burglary Protection
When you enter your home to
disarm the system, if you hear
fast repeated beeps instead of
the normal entry delay beeps,
button erases the entire entry.
if you decide to not disarm
for Silent
15