DB Drive Speed Series Amplifier SPA SPA1600D 사용 설명서 - 페이지 5
{카테고리_이름} DB Drive Speed Series Amplifier SPA SPA1600D에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DB Drive Speed Series Amplifier SPA SPA1600D 9 페이지. Speed series
DB Drive Speed Series Amplifier SPA SPA1600D에 대해서도 마찬가지입니다: 사용 설명서 (17 페이지)
페이지 인쇄
S
IGNAL CONNECTIONS
Connect the RCA output of the head unit (AM/FM cassette player, CD, or DAT) to the RCA
input terminals of the amplifier.
To make these connections, we recommend high quality RCA cables, which are available
at your local car audio retailer. Run signal wires away from electrical wires to avoid possibil-
ity of induced noise from the car's electrical system (i.e. popping noises or engine noise).
in
out
level
L
min max
R
L
R
94.7
in
out
L
level
min
max
R
L
R
94.7
ch 1
x-over
low full high
0dB 18dB
60Hz 400Hz
min max
bass
freq
input
boost
level
ch 2
L
94.7
bass
subsonic
lpf
boost
remote
20Hz 50Hz
40Hz 130Hz
0dB 18dB
spa1300D
classD monoblock amplifier
MONO SIGNAL
Optional full range line out connection
to addition addition in the system.
CONNECTION
x-over
freq
bass boost
low full high
60Hz
400Hz
0dB 18dB
spa90.2
classAB 2 channel amplifier
Optional full range line out connection
SIGNAL CONNECTION:
to addition addition in the system.
2 CHANNEL AMPLIFIERS
input
remote
ch 3
x-over
low full high
min max
60Hz 400Hz
0dB 18dB
input
freq
bass
level
boost
ch 4
spa150.4
classAB 4 channel amplifier
R
L
R
SIGNAL CONNECTION:
4 Channel Amplifier using
2 pair of RCA inputs.
7
S
PEAKER CONNECTIONS
IMPORTANT! The following speaker connection are for the amplifier in normal mono
configuration.
Make the speaker connections using speaker wire that is at least 16 gauge or heavier.
As with any audio component, proper phasing of the amplifier and speakers is essential for
strong bass response. When connecting, make sure that positive (+) from the amplifier is
connected to the positive (+) of the speaker, and the same for negative (-).
Please note that although the SPA1000D, SPA1300D , SPA1600D and SPA1900D are
mono amplifiers, we have provided two sets of speaker terminals on the amplifier. These
terminals are connected in paralleled internally (connected together). The second set of
speaker terminals are intended for ease of connection when running multiple woofers.
R (-) R (+) L (-)
L (+)
speaker
output
(-) ------ bridged ------ (+)
+
-
4 Ohm Speaker
(1Ohm minimum)
R (-) R (+) L (-)
L (+)
speaker
output
(-) ------ bridged ------ (+)
+
-
4 Ohm Speaker
+
-
4 Ohm Speaker
power
fuses
+12v
rem
gnd
protect
power
fuses
+12v
rem
gnd
protect
2 Ohm Speaker (1 Ohm minimum)
8