Celestron StarSense Explorer DX 102AZ 빠른 설정 매뉴얼

{카테고리_이름} Celestron StarSense Explorer DX 102AZ에 대한 빠른 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Celestron StarSense Explorer DX 102AZ 4 페이지.

Quick Setup Guide

ENGLISH

To attach the slow-motion knobs

first locate the supplied hex key hidden inside the

slot in the front of your mount.

Slide the dovetail bar into the clamp at the top of

the mount and tighten the hand knob on the bottom

of the clamp to secure the telescope in place.

102AZ

Unpack your telescope and verify that all parts are

ITEM #22460

present. Your StarSense Explorer DX includes:

a telescope tube, a tripod and mount head, an

accessory bag, slow motion controls, an accessory

tray, two eyepieces, an erect image diagonal, a

finderscope, a StarSense phone dock, StarSense

Explorer app code card, and a hex key (hidden inside

the slot in the front of the mount head).

Extend the legs of the tripod by loosening the three

hand knobs on each leg. Pull each leg section all

the way out and tighten the hand knobs to secure

them in place.

Place the slow-motion control knob over the

to your mount,

D-shaped gear shaft and push inward to make sure

it is fully seated. Use the hex key to tighten the

setscrews onto the gear shaft. Return the hex key to

its storage position in the front of the mount.

Locate the erect image diagonal and remove the

plastic covers. Insert the barrel of the diagonal into

the focuser and secure in place by tightening the set

screws.

To set up the tripod, spread the legs outward until

they are fully extended and push down the center leg

brace.

Place the accessory tray on top of the center brace

and line up the three holes. Insert the three thumb

screws through the bottom of the leg brace and

thread them into the tray.

Hold the telescope tube next to the mount with the

dovetail bar on the tube facing the clamp on the top

of the mount arm.

Insert the barrel of the 25 mm eyepiece into the

diagonal and tighten the set screw.

ENGLISH | 1