ADEMCO 5820 설치 및 설정 매뉴얼 - 페이지 2
{카테고리_이름} ADEMCO 5820에 대한 설치 및 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ADEMCO 5820 2 페이지. Door/window contact transmitter
페이지 인쇄
BATTERY INSTALLATION/REPLACEMENT
Replace battery only with same or equivalent
type.
Dispose of used batteries according to
the battery manufacturer's instruction.
1. Remove the transmitter's cover (if it is
not already off) as described in Mounting
Step 2.
2. Observe correct polarity and insert the
battery provided into the battery retainer
clips as shown in Figure 2.
Note: Replace
battery
specified in the following specifications.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2), this device must accept any
interference received, including interference that may cause undesired operation.
REFER TO THE INSTALLATION INSTRUCTIONS FOR THE CONTROL WITH WHICH THIS DEVICE
IS USED, FOR DETAILS REGARDING LIMITATIONS OF THE ENTIRE ALARM SYSTEM.
¬.l
K9232 12/02
only
with
type
FCC STATEMENT
FCC ID: CFS8DL5820MN
165 Eileen Way, Syosset, NY 11791
^
Copyright
2002 PITTWAY CORPORATION
SPECIFICATIONS
Contact Gap: 0.5 inch maximum
0.5" (12.7mm) x 3.0" (76.2mm) x
Dimensions:
0.8" (20.3mm)
Battery:
1.5V, AAA, Panasonic, Sanyo, or
Duracell.