Gainwise SS1806-3G-H 매뉴얼 - 페이지 8

{카테고리_이름} Gainwise SS1806-3G-H에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gainwise SS1806-3G-H 17 페이지.

7. OPERATION

Programming of the telephone numbers in and whenever the unit receives a call will recognize an

authorized telephone number calling it and will then reject the call without answering (so there will be no

charge) and open the gate or door. The relay can also be temporarily or permanently switched on or off by

sending SMS or dialing in.

This 3G Opener can allow user to gain access from their mobile phone by two methods

1. Caller ID recognition

2. by access control password mode

1. Caller ID recognition to open

Ring in to open the door with authorized telephone number.

2. Access control password to open

Dial the SIM card telephone number. The unit will answer the call and you will hear a bleep tone. The

door can be opened after enter correct password code. Or just simply send SMS password code to the

device.

*71*5678#：Trigger relay 1

*72*5678#：Hold relay 1

*73*5678#：Release relay 1

*74*5678#：Trigger relay 2

*75*5678#：Hold relay 2

*76*5678#：Release relay 2

*This is for door open option when telephone numbers not stored.

Programming can be carried out either by text message or by dialing into the 3G Gate Opener.

8.1 Progrmming by dialing in

Dial the SIM card telephone number. The unit will answer the call and you will hear a bleep tone.

Enter Programming Mode by Pressing.....

*12*1234# (1234 is default password)

A successful pass code will produce a single long beep. A failed attempt will produce 3 short bleeps.

Example: start to program the phone number for dialing in to open the door.

Use the following commands to program the unit

* Insert international country code (1~3 digits): 71[country code] #

* Add a number (up to 1150 numbers):72[relay][phone number] #

* Delete a number: 73[phone number] #

* Delete all numbers: 73*#

3G Gate Opener

8/17

Revision V1.3B, Jan 2020