Celestron 44102 사용 설명서 - 페이지 9

{카테고리_이름} Celestron 44102에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Celestron 44102 20 페이지.

페이지 인쇄

Use the following table to determine the magnification of the different eyepiece/objective lens combination of your

microscope.

Objective Lens

10x Eyepiece

12.5x Eyepiece

1. Take the Styrofoam container out of the cardboard carton.

2. Remove the tape from the Styrofoam container holding the two sections together.

3. Carefully remove the microscope and other parts from the container and set them on a table, desk, or other flat

surface.

4. Remove the plastic bag covering the microscope.

5. Remove the protective paper from the stage (5).

6. Remove the plastic cap from the eyepiece tube (2).

7. Insert the 10x eyepiece in the eyepiece tube (2).

8. Remove the three objective lenses (4) from their containers. Unscrew the container lids from the threaded portion

of the objective lenses.

9. Thread the end of the 4mm objective lens into one of the holes on the nosepiece (12) until finger tight. It may be

necessary to lower the stage (5) by turning the coarse focus knob (3).

10. Now turn the nosepiece to the next opening and thread each of the remaining objective lenses into the remaining

holes.

Using the Illuminator Mirror

Your microscope has a built-in plano-concave illumination mirror which allows you to illuminate the specimen from the

bottom by reflecting an external light source (indirect sunlight, room light, lamp, etc.) to the stage. The mirror has a flat

side (you can easily see your reflection on the flat surface) and a concave side. The concave side will concentrate more

light onto the specimen than the flat side. To illuminate a specimen:

1. If it is daylight, tilt the mirror (6) and reflect indirect sunlight through the bottom of the stage (5). Warning: Never

use the mirror to focus direct sunlight through the microscope as this can be very harmful and may damage your

eyes.

2. If viewing at night or indoors, away from sunlight, you can use a nearby desk lamp, table lamp, or other light source

to reflect light onto a specimen.

To control the amount of light reflecting onto the specimen:

1. Use the concave side of the mirror to focus more light on the slide. The concave side will concentrate more light onto

your specimen but will focus a smaller beam of light, making it more sensitive to adjust.

If you are unable to adjust the mirror enough to properly illuminate the specimen, you can also tilt the arm (10)

backward to change the position of the mirror – see the section under "Adjusting the Arm Angle".

3. You can also control light adjustment with the condenser and diaphragm -- see the section under "Adjusting the

Lighting".

Magnification Table

Setting Up Your Microscope

You are now ready to use your microscope!

Microscope Operation

10x

40x

100x

50x

125x

40x

400x

500x