Dynamic CT-500 설치 지침 및 소비자 정보 - 페이지 2
{카테고리_이름} Dynamic CT-500에 대한 설치 지침 및 소비자 정보을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynamic CT-500 4 페이지. Console air cleaners
Dynamic CT-500에 대해서도 마찬가지입니다: 설치 지침 (4 페이지)
페이지 인쇄Specifications:
MODEL
Airflow Capacity:
Electrical Input:
Power Consumption:
Speed Control:
Cabinet Finish:
Unit Dimensions:
Weight:
Airflow Pattern:
Filter Access:
Pad Change Rate:
db level @1m (front):
Care & Cleaning:
Replacement Media Pads are available by ordering online at www.DynamicAQS.com
free 800-578-7873.
household conditions (applications where smokers are present may require more frequent changes
depending on smoke levels). When the unit is new, it is suggested that the media pad be inspected
and/or replaced after one month of operation due to the initial cleanup of contaminants. For proper
operation, use only genuine Dynamic replacement media pads. Other filter material may cause the unit
to operate improperly and will void the unit warranty.
a. Turn the unit switch to the "off"" position and unplug the unit.
b. Remove the screw in the swing latch if so equipped. (As an extra
safety precaution, a factory installed screw is installed in the swing
latch. It can be re-used or discarded - Figure 1)
c. Open the replacement media pad enclosure in the air cleaner as
shown in Figure 2.
d. Carefully remove the dirty media pad and discard (a plastic trash
bag works well). If dust has accumulated on the outer screen of
the air cleaner, clean with a vacuum or soft, damp cloth.
e. Properly position the new Dynamic replacement media pad so that
the media covers the entire filter space.
f.
Close the rear screen and replace the screw in the swing latch.
g. Plug in the unit and turn the switch on.
h. Position the unit several inches away from walls and furniture to
allow for sufficient airflow to the air intake on the back of the
console cabinet. Placing the unit diagonally across the corner of a
room works well.
i.
Make a record of the date you replaced the media pad and make
a note on your calendar for the next replacement depending on
usage and lifestyle.
CT-100
100cfm (125 fpm)
110V / 1 / 60Hz
200W max.
2 speed
woodgrain, black
18.25"h x 12"w x x8.75"d
(464mm x 305mm x 223mm)
15 lbs. (7 kg)
rear intake / side discharge
rear of unit
2-4 times/year typical
54db hi speed
50db lo speed
Media pads should generally be replaced every 3 to 4 months, depending on
CT-500
500cfm (500 fpm)
110V / 1 / 60Hz
300W max.
2 speed
woodgrain, black
26"h x 23.75"w x 11"d
(660mm x 605mm x 280 mm)
43 lbs. (19.5 kg)
rear intake / side discharge
rear of unit
2-4 times/year typical
58db hi speed
54db lo speed
2
or by calling toll-
Figure 1
Figure 2