Dynamic Polarized-Media 설치 지침 - 페이지 3

{카테고리_이름} Dynamic Polarized-Media에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynamic Polarized-Media 4 페이지. Polarized-media electronic air cleaner

1) Turn the thermostat fan switch to the "OFF" position.

2) Turn off power to the furnace/air handler.

3) Open the filter access door or grille.

4) Unplug the power supply cord from the air cleaner

powerhead.

5) Remove the air cleaner from the filter rack or return

air grille.

6) Open the air cleaner (fig 4), remove the old media pad

and discard.

7) If dust has accumulated on the outer screen of the air

cleaner, clean with a dry brush or vacuum.

8) Position the new replacement media pad so that it is

centered within the air cleaner frame(fig 5).

9) Close and re-latch the air cleaner.

10) Return the air cleaner to its location in he furnace/air

handler or return air grille.

11) Plug the power supply cord into the air cleaner once

it is securely in place (fig 6).

12) Close the filter access door or grille.

13) Switch the thermostat back to the "ON" position. For

optimum results, the furnace or air handler should be run

continuously with the fan switch in the "ON" position,

rather than the "AUTO" position.

14) Because of variations in humidity and temperature,

the new media pad may make a slight snapping sound

when first installed. This is normal and should stop within

24 hours of operation.

NOTE: Media pads generally last 3 to 4 months, depending on household conditions. In a new

installation, however, it is suggested that the media pad be inspected and/or replaced after one

month of operation due to the initial cleanup of contaminants.

WARNING: FAILURE TO CHANGE THE MEDIA PAD ON A REGULAR BASIS COULD REDUCE

AIRFLOW AND CAUSE DAMAGE TO THE HEATING AND COOLING SYSTEM.

Section IV. Replacement Parts

1) Maintenance is limited to periodic replacement of the air cleaner media pads. This is typically

done every 3 to 4 months.

2) Replacement Media Pads can be ordered from your heating and air conditioning contractor or

by ordering online at www.DynamicAQS.com. Have the model number or unit size available

when calling. Refer to the size label on the unit (item 12 in figure 7) for the unit size. Air cleaner

media pads are sized according to the size of the overall air cleaner and NOT the size of the

media pad itself.

3) When giving dimensions, the first dimension given should be the length of the side with the

powerhead.

Figure 4

Figure 5

Figure 6