Celestron 44316 사용 설명서 - 페이지 7

{카테고리_이름} Celestron 44316에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Celestron 44316 13 페이지. Handeld digital microscope
Celestron 44316에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지)

페이지 인쇄

C. TIME-LAPSE CAPTURE

Your MicroDirect allows you to set the device to take images

over a defined time period. This is referred to as Time-Lapse.

You will first select the number of still images or Lapse

Num you want your device to take. This can range from 2

to 999 images.

Use the Down button (9) to scroll through the numbers from

0 to 9. When satisfied with the first digit, press the Mode

button (6) to jump to the next digit.

Again, using the Down button (9), set that digit.

Once the number of still images has been chosen, press the

Mode button (6) to move to the Lapse Time choice.

The Lapse Time determines the amount of time that will

pass between each still image capture.

Set these numbers using the same method as above for the

Lapse Num.

The choices are in seconds and range from 1 second to 999 seconds.

This, along with the number of images, will determine your overall length of time for your time lapse.

For example: If you choose to take 999 total images and the interval between each is 999 seconds you will have 277 hours

documented. 999 seconds = 16.65 minutes. Multiply that by 999 (images) =16,633.35 minutes. 16,633.35 / 60 (minutes

per hour)= 277 hours or 11.55 days of documentation.

Once you have set your number of images and interval, press the Capture/OK button (8) to confirm.

Press the Menu button (7) to return to the streaming image.

Press the Capture button (8) to start the time lapse.

Once all frames have been taken in the Time Lapse mode, the MicroDirect

normal preview mode.

NOTE:

The AUTO POWER OFF time needs to be set to a number higher than the set Time Lapse time. See section on AUTO POWER

OFF FEATURE and make sure to do your calculations correctly.

1080p HD microscope will revert back to the

ENGLISH