Gait up PhysiGait Lab 사용자 설명서 - 페이지 14

{카테고리_이름} Gait up PhysiGait Lab에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gait up PhysiGait Lab 18 페이지. User manual and outcome parameters

Foot-flat phase [%] is the portion of the stance where the foot is fully flat

on the ground.

Pushing phase [%] is the portion of the stance between the foot being flat

on the ground and the toe leaving the ground at take-off.

6.3

Spatial Analysis

Stride Length [m] describes the distance between two successive

footprints on the ground, from the heel of a foot to the heel of the same foot,

one cycle after.

Stride Velocity [m/s] is the forward speed of one cycle. See "Speed" in

essentials.

Peak Angle Velocity [deg/s] is the maximum angular velocity during the

swing phase, between max heel clearance and min toe clearance.

Measured by the gyroscopes, this parameter is a raw sensor measure which

is not subject to any calculation errors. It can be used as a robust asymmetry

measure.

Maximal Swing Speed [m/s] is the maximum forward speed of the foot

during swing. This speed is usually obtained around minimal toe clearance

and it is usually equal to more than3 times walking speed.

Strike Angle [deg] is the angle between the foot and the ground at heel

strike, on a vertical plane.

Lift off Angle [deg] is the angle of the foot at the end of the push phase,

just at take-off.

Swing Width [m] is the maximal lateral excursion of the foot during swing

phase. It is the maximum lateral distance between the forward path and the

real path of the foot.

3D Path Length [% stride length] is the length of the real path of the foot

during one cycle in 3D space, including both stride length and swing width.

PhysiGait Lab user manual v1.3.1 Date: 29.04.2019

EPFL Innovation Park, Bat C. CH-1015 Lausanne

Gait Up SA

www.gaitup.com

TVA CHE-145.136.760