dB Technologies B-HYPE MOBILE 사용자 설명서 - 페이지 5
{카테고리_이름} dB Technologies B-HYPE MOBILE에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. dB Technologies B-HYPE MOBILE 18 페이지. Bi-amp battery-powered speaker
페이지 인쇄POWER SUPPLY UNIT SECTION
This section contains:
•
connector for the supplied power supply cable
•
three-state switch:
ON - full operation of all functions
and operation both with network cable and
with battery only in mobile mode.
OFF - no operation (device completely off)
RECHARGE - the system in stand-by,
connected to the network, recharges the
inner battery and the BT-BHM radio
microphone, if any.
SECTION FOR THE CONNECTIONS, CONTROL AND MONITORING OF THE BATTERY
This section contains inputs/outputs and volume
mixer adjustments. All monitoring LEDs of the
system and of the internal battery are also present.
In particular, the following can be found:
•
CH1: Combo connector (XLR/TRS) with relevant
input type switch and volume rotary switch. If
a microphone is connected, select the position
Mic.
•
CH2: The connectors available are AUX (3.5 mm
mini-jack) and RCA stereo with relevant volume
rotary switch of the channel.
•
MASTER SECTION (3 rotary switches): general
volume switch, TREBLE and BASS equalization
rotary switches.
•
VOLUME ROTARY SWITCH
it controls the volume of the playable media
(see section "MEDIA PLAYER INTERFACE" for
further information)
•
Line Output: unbalanced connector to link
the B-HYPE MOBILE output to another active
loudspeaker (e.g. another B-HYPE MOBILE
system). For example, the Line Output of a
B-HYPE MOBILE can be connected to the CH1 of
a second one to obtain a distributed system.
•
CH1/RF Priority. In "On" position the audio
level of the 2 channels CH2 and
SD is immediately reduced by the presence
of a signal on CH1 or on the radio frequency
microphone.
WARNING
Whenever possible, charge the battery completely. Never store it completely empy or
half empty. If the device is inactive for a long period, disconnect the battery, covers the
terminals and store the battery in a dry place away from heat sources, and regularly
recharge the battery.
B-HYPE MOBILE
26
/USB/SD:
/USB/
!
The monitoring LEDs of the system and of the
internal battery provide immediate information to
the user.
The POWER LED indicates whether B-HYPE MOBILE
is on (green light) or off.
The internal battery will recharge with B-HYPE
MOBILE connected to the power mains (through
the cable supplied) and in RECHARGE position. The
also during the operation in ON position.
green when completely charged.
When B-HYPE MOBILE is used in mobile mode
(without power supply cable), in ON, the Battery
level LEDs turn on depending on the battery charge
status.
English
Code 420120272 REV. 1.2