Airdog KJ200F-X3 사용자 설명서 - 페이지 5

{카테고리_이름} Airdog KJ200F-X3에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Airdog KJ200F-X3 8 페이지.

Full Cleaning Cycle

1. We recommend a complete cleaning every 6-12 months.

2. First, unplug the power supply.Open the back shroud. Pull out the ionization wire frame and collecting plates.

Pull out the protective rubber sleeve as illustrated (in Pic 1).

3. Clean the ionization wire frame very gently with a soft sponge, wiping in 1 direction, and clean the collecting plates

with water and a rag.

4. Use a wet cloth to wipe down all surfaces of the protective rubber sleeve, including notches. For better results,

wash the entire rubber sleeve in water.

5. Clean the inner walls of the air puriﬁer with a soft cloth (Pic 2).

6. Wash the pre-ﬁlter in water, clean it by vacuum, or brush it gently with a soft brush.

7. Dry the parts completely, 100% dry, and then put them back in order.

Pic 1

Pic 2

Air Quality Sensor Cleaning

Airdog air puriﬁer has an embedded air quality sensor. To keep

the air quality sensor reading correctly, please clean the sensor

every 6 months, using a dry soft rag or cotton swabs with

rubbing alcohol as illustrated.

Reminder

1. Please take out the line cord directly from the back (Pic 1). DO NOT coil or run the power cord under the bottom

of the air puriﬁer. Keep it free and clear from obstructions (Pic 2, Pic3).

2. ONLY use the original adapter.

3. Follow the instructions above to avoid creating problems with the electromagnetic compatibility of the puriﬁer.

Pic 1 Correct

Pic 2 Wrong

Pic 1

Pic 3 Wrong