2gig Technologies Touch Screen Wireless Keypad 빠른 매뉴얼 - 페이지 3

{카테고리_이름} 2gig Technologies Touch Screen Wireless Keypad에 대한 빠른 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 2gig Technologies Touch Screen Wireless Keypad 5 페이지. Touch screen wireless keypad for remote control of the 2gig security system

페이지 인쇄

LEARNING/PAIRING THE KEYPAD WITH THE

CONTROL PANEL

Make sure that the Control Panel has power using the supplied AC

adapter and confirm that the adapter is connected.

A Control Panel without the 900 MHz Transceiver

WARNING:

installed cannot communicate with the TS1.

Make sure that the TS1 has power from the supplied AC transformer.

Connect the AC adapter to the TS1. Confirm that the wires are

connected using the correct polarity.

As the TS1 powers up, the following message is visible on the display.

From the Control Panel's Installer Toolbox, select System

Configuration.

Select the Go To button.

To go to question 4, enter 04.

Select the RF Keypad number to assign to the TS1. Use the → arrow

to select the RF Keypad number (1‐4). After selecting the RF Keypad

number, press the ↓ arrow to start conﬁguring the speciﬁc

parameters for the RF Keypad.

Press the → arrow or press the number 1 on the keypad toggle the

se ng on the ﬁrst ques on to "used". Press the ↓ arrow to con nue

configuring options.

Set the RF Keypad Equipment Code to 1059 by pressing the ↓ arrow

until "(1059) 2GIG‐TS1 wireless touchscreen keypad" appears. Press

the ↓ arrow to advance to the next op on.

Learn the TS1 into the Control Panel. A er pressing the ↓ arrow in

the previous step, the Learn button appears.

INITIATING THE PAIRING PROCESS

Initiate the pairing process at the Control Panel by pressing the Learn

button.

On the Control Panel press the Learn button.