Hidro-Water NELVA 매뉴얼 - 페이지 7

{카테고리_이름} Hidro-Water NELVA에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Hidro-Water NELVA 17 페이지.

The other end of the ⅜" tube must be connected to

the ultrafiltration system's outlet, which is marked

"GRIFO" (Faucet). To do so, you must unscrew the

straight nut on the system's outlet. Then insert the

⅜" tube through the nut and place a plastic insert

(Figure 6) in it. Screw the nut back on the straight

on the ultrafiltration system's outlet.

Here is a diagram of how the ultrafiltration system should be installed.

5. U

LTRAFILTRATION SYSTEM START

a. Make sure that all the connections are connected properly

and tightened.

b. Make sure that the arm of the WATER STOP Antileak sys-

tem is down like shown in the figure so that the water can

enter the ultrafiltration system.

c. Open the water supply and then the ball valve (fig-

ure 5) as shown. Make sure there is no water leak.

If there is, close the valve and fix it.

d. Open the faucet (Figure 2) and let all of the air out

from inside the ultrafiltration system. Once a contin-

ual water flow comes out of the faucet, let it run for 30 seconds and then close the

faucet. If in the beginning, the water runs black, don't worry, this is normal, it's

caused by the residue that the granulated carbon filter lets off. Drain this water. The

water will run clear not long after this.