Hidro-Water KOBE WS1CI UF 사용자 및 설치 관리자 매뉴얼 - 페이지 6

{카테고리_이름} Hidro-Water KOBE WS1CI UF에 대한 사용자 및 설치 관리자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Hidro-Water KOBE WS1CI UF 19 페이지. Water conditioning system

페이지 인쇄

5.3.2 Hydraulic connections level

75 mm

The distance between

Height from the floor to

the centre of the inlet and

the centre of: inlet / outlet

outlet connections on

and overflow

CLACK WS1CI valves

KOBE 14L Model

5.3.3 By-Pass

To ease maintenance or repairs without cutting the water supply, a bypass system must

be installed. The most common bypass systems are using ball valves or the bypass for Clack

WS1CI valves.

CLACK By-Pass

BYPASS:

Direct water supply

without going through

the softene

OPERATIONAL:

Water goes through the

softener

MA-EN-DESCALCIFICADOR KOBE (USR) UF-3004-XX JD18V01

Height from the floor to

the centre of: inlet / outlet

and overflow

KOBE 22 y 35L Model

External By-Pass

Installing Kobe's original bypass:

Among the accessories that come with the system, you can find the Kobe system's original

bypass and the system's inlet and outlet connections (items 5 and 3 on the accessories list)

which are located in the salt tank as mentioned in the unpacking the system section (5.1).

System installation is very straightforward and doesn't require any tools.

a. Prepare all of the pieces that you're going to need.

b. In the slot that's closest to the thread, we must place the supporting washer (white) on the

inlet/outlet connector.

c. In the slot that's furthest from the thread, we must place the O-ring seal (black) on the

inlet/outlet connector.

d. Insert the connector on the bypass's inlet or outlet (on the side that has a male thread)

e. Fix it into place by screwing on the fastening nut included in the inlet – outlet connectors.

Repeat steps b, c, d, & e for the other connector.

g. Insert the opposite end of the bypass (part with seals) in the rear part of the valve (inlet

and outlet)

h. Fix it into place using the two fastening nuts included in the bypass.

Now the bypass is fully set up.

Fig. a

Fig. b

Fig. c

Fig. f

Fig. g

Lubricate the O-ring seals once placed on with any type of grease. It will

allow the parts to be inserted more easily.

MA-EN-DESCALCIFICADOR KOBE (USR) UF-3004-XX JD18V01

Fig. d

Fig. e

Fig. h

Fig. i