ActivePure B1013U 매뉴얼 - 페이지 9

{카테고리_이름} ActivePure B1013U에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ActivePure B1013U 16 페이지.

REPLACING THE BALLAST

• UV Light in operation; disconnect unit from power cord before servicing; failure

to follow warnings may result in severe eye damage

• Disconnect power at the breaker or fuse panel before servicing unit;

always follow OSHA lockout procedures to prevent accidental exposure to

electrical energy

WARNING

Power

Cord

1. Disconnect (unplug) power cord from unit.

NOTE: Always follow OHSA electrical lockout safety requirements to prevent accidental release of energy

during service or maintenance activities.

3. Disconnect all ballast wiring by pressing

down on connector tabs and pulling wire

straight out.

5. Place new ballast into original location and secure using the two (2) nuts removed in step 4.

2. Open the ballast housing by removing the

four (4) screws then removing the cover.

4. Remove the two (2) nuts securing ballast to

the case. Remove the ballast.