ActivePure Induct Guardian I 매뉴얼 - 페이지 6

{카테고리_이름} ActivePure Induct Guardian I에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ActivePure Induct Guardian I 16 페이지.

FIBERGLASS DUCTWORK INSTALLATION

Power Connection Requirements: This device is designed to operate using

a 24 VAC, 40Va transformer. Transformers supplied with a straight cooling

or HVAC system may be used to power the device but must be verified it's

capable of handling the additional device load before installation. If the system

transformer is not capable of handing the extra load, a separate 24 VAC, 40Va

WARNING

transformer MUST be used. Do not connect the device to any power source

with a voltage less than 22 VAC and a maximum of 32 VAC. Doing so will cause

damage to the device.

1. Locate suitable area of

duct for installation.

3. Cut hole in duct using 3.5" hole saw.

ALTERNATE CUTTING METHOD

a. Using the mounting plate, mark 4

holes for alternative cutting method

on duct. If, not already done, mark 4

corner holes.

c. Cut between holes using a utility knife. Continue with #4 (above).

2. Mark location for 3.5" opening using

the mounting plate. Also mark the

locations of 4 screw holes in corners.

4. Drill 4 holes (at corner screw

locations) using a 3/8" drill bit.

b. Draw a line between each

alternative cutting method marks

(as shown).