ActivePure Surface & Air Guardian 매뉴얼 - 페이지 10
{카테고리_이름} ActivePure Surface & Air Guardian에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ActivePure Surface & Air Guardian 14 페이지.
ActivePure Surface & Air Guardian에 대해서도 마찬가지입니다: 매뉴얼 (16 페이지)
페이지 인쇄REMOVING THE ACTIVEPURE
WARNING:
CAUTION:
NOTE:
Use genuine ActivePure
warranty.
1. Unlock the ActivePure
Cell connector by pressing
on the connector's
locking tabs.
INSTALLING THE ACTIVEPURE
WARNING:
1. Slide the ActivePure
up and into the unit. Be
sure the back lip of the
ActivePure
the two slotted protrusions
at the rear of the unit, and
that the angle brackets and
studs are correctly aligned.
4. Replace the Filter
10
CELLS
®
• Unplug the unit before performing any maintenance procedures
• Do not operate the ActivePure
properly installed
Do not look directly at the glowing lamp. Prolonged exposure, even to reflected UV light, can cause eye damage
according to the American Conference of Governmental Industrial Hygienists (ACGIH) Standards.
replacement parts only. Parts from anyone other than ActivePure
®
2. Pull the connector
®
straight out to unplug.
®
• Unplug the unit before performing any maintenance procedures
• Do not operate the ActivePure
properly installed
Cell
®
Cell engages
®
Assembly, inserting
the bottom of the
Filter Assembly first.
Surface & Air Guardian without the Filter Assembly and Back Cover
®
3. Remove two (2)
CELLS
Surface & Air Guardian without the Filter Assembly and Back Cover
®
2. Insert the two
thumbscrews and
tighten. Insert the
ActivePure
connector into the plug
at the rear of the unit.
5. Replace the Back Cover
by inserting the bottom
in first and snapping it
into place.
may damage your unit and void your
®
thumbscrews.
Cell
®
4. Slide the
ActivePure
Cell
®
down and out of
the unit.
3. Press the
connector firmly
until the two tabs
lock into place.