ActivePure Surface & Air Guardian 매뉴얼 - 페이지 11
{카테고리_이름} ActivePure Surface & Air Guardian에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ActivePure Surface & Air Guardian 16 페이지.
ActivePure Surface & Air Guardian에 대해서도 마찬가지입니다: 매뉴얼 (14 페이지)
REMOVING THE ACTIVEPURE® CELLS
CAUTION
WARNING
NOTE: Use genuine ActivePure replacement parts only. Parts from anyone other than ActivePure may damage your unit
and void your warranty.
1.
Unlock the ActivePure Cell
connector by pressing on
the connector's locking
tabs.
INSTALLING THE ACTIVEPURE® CELLS
WARNING
1.
3.
5.
Do not look directly at the glowing lamp. Prolonged exposure, even to reflected UV light,
can cause eye damage according to the American Conference of Governmental Industrial
Hygienists (ACGIH) Standards.
• Unplug the unit before performing any maintenance procedures
• Do not operate the ActivePure Surface & Air Guardian without the Filter Assembly and
Back Cover properly installed
2.
Pull the connector
straight out to
unplug.
• Unplug the unit before performing any maintenance procedures
• Do not operate the ActivePure Surface & Air Guardian without the Filter Assembly and
Back Cover properly installed
Slide the ActivePure Cell up and
into the unit. Be sure the back lip
of the ActivePure Cell engages
the two slotted protrusions at the
rear of the unit, and that the angle
brackets and studs are correctly
aligned.
Press the connector firmly
until the two tabs lock into
place.
Use the included screwdriver
to screw in the Filter Assembly
3.
Remove two (2)
thumbscrews.
2.
Insert the two thumbscrews
and tighten. Insert the
ActivePure Cell connector into
the plug at the rear of the unit.
4.
Replace the Filter Assembly,
inserting the bottom of the
Filter Assembly first
6.
Replace the Back Cover by
inserting the bottom in first
and snapping it into place.
4.
Slide the ActivePure
Cell down and out of
the unit.
11