Gakken Stirling engine 조립 및 작동 지침 - 페이지 7
{카테고리_이름} Gakken Stirling engine에 대한 조립 및 작동 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Gakken Stirling engine 12 페이지.
페이지 인쇄14
14
Figure ー
Attach the control lever.
Attach the control
lever finished at
12
Figure ー ,to the
body finished at
Figure ー with
9
D1
control lever
6mm screws. Then,
move each lever and
check the operation.
(If there are any
loose levers, tighten
the nut.)
the fore
part
Full-scale
※Check the size with this.
screw (6mm)
15
15
Figure ー
Attach the E4 main piston.
Insert the E4 main
piston into the C1
cylinder.
the hinder
part
16
16
Figure ー
Attach the E7 displacer.
Put the shaft of the
E7 displacer through
the E3 displacer
holder and then into
the center hole in the
the hinder
E4 main piston.
part
screw (6mm)
screw (6mm)
the hinder
part
B1
body
(Pay attention to the
direction of the body.)
C1
cylinder
E4
main piston
the fore part
C1
cylinder
E4
main piston
E3
displacer holder
E7
displacer
the fore part
12
17
17
Figure ー
Attach the E5 connecting rod.
Attach the E5
connecting rod to the
shaft of the E7
displacer using the
E5
connecting rod
E6 displacer
adjuster.
18
Figure ー
E6
Fasten the following
displacer adjuster
parts in this order.
washer (7mm in
the hinder
part
diameter)
E5 connecting rod
18
Attach two connecting rods to the fly wheels.
the connecting rod of
the E4 main piston
(The shaft of the displacer is not illustrated to simplify the diagram.)
nut (small 5mm)
※Pay attention to the position
nut (small 5mm)
of the connecting rods
at the dotted circle.
How to connect the connecting
rods and the fly wheels
the upper
nut (small 5mm)
part
washer
nut (small 5mm)
(7mm in diameter)
E5
E6
E4
displacer
adjuster
the
the lower
hinder
part
part
E5
nut (small 5mm)
nut (small 5mm)
washer
E4
Fasten at the place where the shaft is coming out about 30mm temporarily.
● How to screw two
nuts at once.
Hold the inner nut
with the wrench and
screw the outer nut
with the small nut
wrench.
Warning ★ Fire is used for the experiment. Use great caution to avoid
a burn and fire. Do not let a 15 or less-year-old child experiment alone.
E7
the fore part
E5
connecting rod
the connecting rod
E4
of the
main piston
nuts (small 5mm)
washer
(7mm in diameter)
nut (small 5mm)
nut (small 5mm)
washer
wrench
small nut wrench
13
displacer