GALA A270 사용자 설명서 - 페이지 4

{카테고리_이름} GALA A270에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GALA A270 10 페이지.

페이지 인쇄

BOAT ASSEMBLING

Step 1:

- Inspect the condition of the package for and

report to your dealer if you find any damages.

Open the boat

- Remove all the packaging plastic and

cardboard carefully. Do not use knife.

- Check the completeness of the boat and

make sure that no any parts are missing. You

must report the missing part to your dealer

immediately.

Step 2:

- Open the pump, connect the pump hose to

Inflate the boat

the pump onto inflation opening.

- Connect bayonet adapter of the pump hose

to the valve

- Inflate the rear compartments first up to

pressure slightly below nominal, and the bow

compartment the last up to the nominal

pressure. In this case the flexible baffles in the

tube will move towards the rear compartments

and equalize the pressure in all compartments.

You may use the manometer to measure the

pressure level to ensure the best performance

of the boat and make sure that the pressure is

about nominal level. Nominal tube pressure is

mentioned on Capacity Plate

Unpack the seats and install them. For that

Step 3:

slide the side seat railings into the seat slots

Install the seats

on both sides. Always keep the seats at a

distance not less than 100mm (4 inches) from

the seat rail ends.

Step 4:

- Assemble the oars: connect the oar blade to

Install the oars

the oar tube and make sure that the fixation

pin is locking the blade properly.

- Insert oarlock stainless steel pin into the oar

hole and secure it with the oarlock cup tight.

- to store the oar in boat running position insert

the oar tube into the oar holder and make sure

that the oar is held there tight.

Step 5:

Install the motor following your motor User's

Install the motor

Manual instructions.

- 4 -

VALVES OPERATION

INFLATION-DEFLATION VALVE operation:

OVERPRESSURE VALVE operation:

DRAIN VALVE operation:

OVERINFLATING AND OVERHEATING OF YOUR BOAT MAY CAUSE THE

BOAT DAMAGE. AVOID OVERPUMPING THE BOAT, LEAVING THE BOAT

NOT COVERED, USING HIGH-PRESSURE INFLATORS. USE MANOMETER TO

CHECK THE PRESSURE IN THE TUBE REGULARLY.

WARNING

- 5 -

Inflation-deflation valve has PUSH-

PUSH operating system: pressing

the central pin the valve switches

between OPEN and CLOSED. To

inflate the tube put the pin to

CLOSED position (pin moves UP).

To deflate the tube put the pin to

OPEN position (pin moves DOWN).

After inflation every valve must be

closed with the valve plug tight to

ensure airtightness of the tube.

Overpressure valve protects the

boat against unexpected pressure

increase over the maximum working

limit. In case of any tube pressure

increase or overinflating the gasket

of the valve will open automatically,

release all excessive air and bring

the tube pressure to nominal. Make

sure that the valve cup is always

clean. Check the valve operation

during boat maintenance.

Drain valve includes: a) expanding

plug inside of the cockpit with

opening-closing lever, b) one-way

drain valve with elastic petal. To

drain the water from the cockpit:

- open and remove the expanding

plug from the through-hull,

- start the engine and move the boat

with speed 8-12 km/h until the water

drains out of the boat completely,

- put the expanding plug back and

close it.