Celestron NexStar GT 소유자 매뉴얼 - 페이지 2

{카테고리_이름} Celestron NexStar GT에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Celestron NexStar GT 16 페이지. Nexstar hand control
Celestron NexStar GT에 대해서도 마찬가지입니다: 통신 프로토콜 매뉴얼 (8 페이지)

페이지 인쇄

Coupling

Screw

A) Remove the NexStar from its packaging. Spread the

tripod legs apart until the center leg brace is fully

extended and attach the accessory tray. B) Extend the

tripod legs to the desired height. C) Set the telescope fork

arm base into the tripod head and thread the coupling

screw into the bottom of the base.

Eyepiece

Focus Knob

Star Diagonal

A) Attach the included accessories. Loosen the thumb screw at the

end of the focuser and remove the protective plastic cap. Insert the

diagonal (60mm and 80mm models only) and low power eyepiece

(25mm or 20mm) into the barrel of the focuser. B) Remove the

front lens cover from the end of the telescope. C) Attach the Star

Pointer finderscope and remove the plastic cover over the battery

and turn-on the Star Pointer by rotating the dial on the side. (For

instructions on aligning the Star Pointer, see the Assembly section of

the manual).

Fork Arm

Base

Tripod Head

Accessory

Tray

Star Pointer

Hand

Control

Outlet

Install 8 AA batteries into the battery pack. Plug in

the hand control and the battery pack into the

outlets on the fork arm base.

The first time the NexStar is powered on the display will

read Select Model. Use the Up and Down scroll buttons to

select your NexStar model from the list and press ENTER.

When the display reads NexStar Ready, press ENTER to

AutoAlign the NexStar. The hand control display will ask

you to move the telescope tube so that it is level with the

ground and facing the north horizon. Use the direction

arrow buttons on the hand control to position the telescope

north and level. (See Astronomy Basics for help on finding

north).

Battery

Pack

Outlet