Celestron 47011 사용 설명서

{카테고리_이름} Celestron 47011에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Celestron 47011 15 페이지. Personal weather station with wireless remote sensor

Personal Weather Station with Wireless

Set Up the Power for the Receiver

Finally, insert the plug into an AC wall type socket and the display will be seen on the Receiver.

For optimum performance, please place the Receiver away from metal and other sources of

interference such as mobile phones, TVs, computers, appliances, etc.

Set Up the Power & Make Settings for the Wireless Remote Sensor

Remove the four small screws from the rear door of the sensor with a small Phillips

head screwdriver. Insert two AAA batteries (user supplied) according to the polarity as

indicated on the sensor (see center image). Set the switch (on the right side) to 1 (for

Channel 1), push/toggle the center switch so readings will be shown in "C"

(Centigrade) or "F" (Fahrenheit). Then push the left switch "TX" which will transmit

the RF signal from the sensor to the Receiver. The Sensor itself will display the outside

temperature and humidity (see left image).

The Sensor can be mounted up to 100 feet (30 meters) in an open area from the Receiver to

communicate with it. The Sensor has a place on the rear of the unit to mount/hang it securely to any

surface that is secure.

If the battery power becomes low on the Sensor, a "low battery icon" will appear on the LCD display

and change batteries to ensure a strong signal is being sent to the Receiver.

The Receiver has two LR44 batteries installed so that the time and other settings will remain in

memory when the Receiver loses power for some reason. Pull out the plastic insulation sheet from the

back to make it functional.

Remote Sensor

Model # 47011

Plug the socket of the AC Adapter into the

back of the Receiver unit (shown in bottom

right image below). Then install the plug

required for your location (four plugs are

supplied-USA/Europe/UK/Australia).

To change plugs push down on the

indented section (with a small screwdriver

or other small object) and pull the plug away from the adapter --- then

install the plug you want to use into the adapter until you hear it click.