Celestron 93711 사용자 설명서 - 페이지 3

{카테고리_이름} Celestron 93711에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Celestron 93711 12 페이지.
Celestron 93711에 대해서도 마찬가지입니다: 사용자 설명서 (12 페이지)

Quick start

1. Place the CD into your computer's CD rom drive.

2. Install both the NexImage iCap and RegiStax software

onto your computer.

3. Thread the 1.25" nose piece into the body of the

NexImage camera. see Fig 2.

Fig 2

4. Slide the 1.25" nose piece of the camera into the eyepiece barrel of your telescope. see Fig 3.

Fig 3

5. Plug the small end of the USB cable into the port on the back of the camera.

6. Plug camera into the USB port of your computer. Once connected, the Found New Hardware

message will appear. Follow the Installation Wizard until the device has been successfully installed.