Hidrotermal HIDRO-SPOT60H 설치 및 유지 관리 매뉴얼 - 페이지 4

{카테고리_이름} Hidrotermal HIDRO-SPOT60H에 대한 설치 및 유지 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Hidrotermal HIDRO-SPOT60H 4 페이지. Embedded underwater led swimming pool light

페이지 인쇄

3. RGB Light Color Control Operation

17 pre-programmed color modes of RGB light:

RGB change automatically

BLUE: static blue

GREEN: static green

BG: static cyan-blue

RGB: static white

R-RG-G slow animation

B-BR-R slow animation

B-R-G change from slow to fast

G-RB-B-R-RGB-GB-RG

RGB Operation:

1. Any of the 17 modes can be selected with the ON/OFF switch of your pool lights.

2. Turn the light ON. The first time the light is turned on, the color begins with RGB (mode 0).

The 17 color modes will begin to run automatically.

3. To change the color, turn the light OFF and then ON within 1.5 seconds. Continue turning

OFF and ON until the desired light color mode is reached.

4. When the light is turned OFF for more than 1.5 seconds, it will return to the beginning of the

color cycle (mode 0).

Remote Controller Options: There are 2 optional control ways

1) Power switch control, 2) Wi-Fi remote Control (WIFI-103)

The color modes can also be selected with the controller. One remote control device can be

adapted to 30 pool lights simultaneously within 100 meters.

4. Maintenance and Replacement

1. There is no maintenance required for this light. It is designed to be used only once, meaning

that replacement is necessary if it becomes defective. The repairing is impossible.

2. Before servicing the light, always disconnect power at the circuit breaker to it. Make sure there

is NO voltage supplied to the light.

3. To replace the light, unfasten it from the bracket. Make sure the new light is the same switch.

5. Warranty

1. The manufacturer warrants this led underwater light against defect in materials and

workmanship for a period of two (2) year from the date of purchase.

2. This warranty is limited to the first retail purchaser, it is not transferable, and does not apply to

products that have been moved from their original installation sites. This warranty does not cover

failures or malfunctions from improper installation and/or operation.

3. The manufacturer is not responsible in any circumstances for assembly, installation or start-up

of any electric components which have been inserted or handled at locations other than its own

premises.

4. The liability of the manufacturer shall not exceed the repair or replacement of defective parts.

It specifically excludes liability for direct , incidental or consequential damages.

RED: static red

RB: static purple

RG: static yellow

RGB change gradually to G/R/B

G-GB-B slow animation

RG-GB-BR slow animation

R-G-B change from slow to fast

R-G-B gradually change