ADEMCO TeleCommand 사용자 설명서 - 페이지 17

{카테고리_이름} ADEMCO TeleCommand에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ADEMCO TeleCommand 20 페이지. Telephone module

Program the module as follows:

1. Pick up your home telephone connected to the same line as

TeleCommand and press the [#] key within the initial 5 seconds of

dial tone to activate TeleCommand.

2. Enter your TeleCommand User Code, ex. [1] + [2] + [3] + [4].

TeleCommand will announce your security system status.

3. Press [#] + [0] + [0] to enter the programming mode:

TeleCommand will prompt you to select Zone Descriptor.

You may select the zone descriptor options in any order. TeleCommand

will repeat the prompts from the beginning of the menu each time a

prompt has been selected and a valid entry made.

TO PROGRAM

Zone Descriptor

Protection Against Outside Tampering

TeleCommand is locked out automatically for 20 minutes as a result

of possible tampering caused by improper keying of codes on a call-in

from outside. If this occurs repeatedly over a short period of time,

exercise caution (if the improper keying was not caused by you or

another authorized user). An unauthorized person may be attempting

to access your security system from outside.

Miscellaneous Functions (cont)

PROGRAMMING ZONE DESCRIPTORS

PRESS

ENTER

[6]

3 digit zone

number

THEN TO

RECORD = Press [1]

ERASE = Press [2]

PLAYBACK = Press [3]

SELECT ZONE # = Press [4]

PREVIOUS MENU = Press [8]

EXIT PROGRAMMING = Press

[9]

Two beeps will sound,

confirming program mode

exited.