Hidrotermal Hidro-ST180 사용자 설명서 - 페이지 4

{카테고리_이름} Hidrotermal Hidro-ST180에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Hidrotermal Hidro-ST180 12 페이지.

1. Installation and Procedure

1-1. Installation Place

A. The steam generator should be installed in a dry, well ventilated location, and provided adequate

drainage. You can install the steam generator under a closet, attic, shelf, or basement. And it must

be locked without movement. Please See Figure1.

B. This series steam generator can be installed on the wall or on the floor, but the unit must be level

precisely. There are two mounting holes on the back of the generator, the screws must set in with

strong expansion bolts or equivalent supports.

C. The steam pipe should enter into the steam room and total length less than 6meter. and set it at

least 300mm above the floor or 150mm far away from the seat.

D. The generator should be mounted in a minimum 0.25m³ space.

E. The mounting location should minimize the number of bends and elbows in the steam lines.

F. Should not be install in the cold area or the place easy to ice up.

G. The steam spout, water inlet, and the drainer are installed on left, it can exchange the position

depend on the locale.

Please select the best mounting location under being satisfied to the above requirement.

Figure 1: Location of Installation