Hidrotermal Hidro-ST90 사용자 설명서 - 페이지 5
{카테고리_이름} Hidrotermal Hidro-ST90에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Hidrotermal Hidro-ST90 12 페이지.
페이지 인쇄
1-2. Installation and Wire connection
A. Connect the water inlet, install rinse valve and drainage pipe. Refer to A-Connection Scheme.
B. Connect the power supply wires respectively to L1, L2, and L3 on the junction box. Neuter wire
must be connected to N and electrical grounding must be connected to earth. Refer to B-Power
Connection.
C. Be sure the above-mentioned installation instructions have been correctly followed, and then the
generator is ready for a trial operation in accordance with operating instructions.
1)-Connection Scheme
Hidro-ST30
Hidro-ST45
Hidro-ST60
Hidro-ST105
Hidro-ST120
Hidro-ST150
Hidro-ST180
Cable connection
Water inlet
Steam outlet
Rinse valve
Cable
Set up the cover and nozzle
connection
to the sauna room pipe which
connected from the steam
outlet pipe.
Steam outlet
Safety Valve
Water inlet
Rinse valve
Hidro-ST60B
Hidro-ST80
Hidro-ST90
Cable
connection
Water inlet
Steam
Safety
Rinse
valve
Connect the
controller's wire
to the mainboard