CELETTE DUO SPOT 원본 매뉴얼 - 페이지 11

{카테고리_이름} CELETTE DUO SPOT에 대한 원본 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CELETTE DUO SPOT 20 페이지.

OPERATION SUGGESTIONS:

The machine is different from traditional spot welder, it use patent power source design. The peak output

current is over three times of traditional welder and the welding current is reduce to several msec. So

it can greatly reduce welding heating effect for the car body and keep good surface. But caused by high

welding current, if the output circuit is poor contact, it may burn black the work piece. It need good

conduction and good contact.

Please note the following suggestion:

1. Polish and clean the work piece, whatever welding point or earth connection point.

2. The earth cable need to good contact and close to the welding point. Use two earth clamp when

aluminum stud welding. The welding point should be between the two earth clamp and keep equi-

distance. It can avoid to arc deflection and improve the success rate of the welding.

3. Polish and clean the washer and electrode.

4. When use quick puller slide hammer or h type puller, make sure screw tight all conductive parts.

5. Press the torch, washer, electrode on the work piece with more strength, when welding operation. It

is good for conduction. Please don't welding with weak pressure contact.

3.7 CONTROLS ON GENERATOR FRONT PANEL:

There is two mode for choice.

Auto mode:

After the welding torch and earth cable short circuit or contact for 0.5s,the machine will

produce the output.

Manual mode: Trigger on the torch, the machine will produce the output.

Welding parameter save.

Finish adjust welding mode and welding power, the user can press "save" for save the setting.

C/D: Welding parameter save.

Φ 4~5 steel stud

Round washer/ tab shooter

Quick puller slide hammer

Star washer/steel tab

Triangle washer/ American stud

Choose the welding mode, the system will auto match welding power.

And the power indicator display the power level 1-10 on the right side.

www.celette.com

Page No: 11