Dynamic Precision BPC 7.3 사용자 설명서 - 페이지 9
{카테고리_이름} Dynamic Precision BPC 7.3에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynamic Precision BPC 7.3 11 페이지. Passive balanced stereo control unit
페이지 인쇄SYMPTOM
Noise when adjusting listening
volume.
Noise when adjusting listening
volume.
Noise when changing signal
source.
Noise when changing signal
source.
Hum.
BPC 7.3
POSSIBLE CAUSE
RF-noise.
DC voltage present on signal
source output.
RF-noise.
DC voltage present on signal
source output.
Faulty signal cable, the shield is
either broken or not connected.
TROUBLESHOOTING
POSSIBLE SOLUTION
Mains filter/ferrite core.
Check if a DC voltage is present
on the signal source output.
Mains filter/ferrite core.
Check if a DC voltage is present
on the signal source output.
Change the cable or connect the
shield. Please observe figure 3
and 4 at page 6.
Page 8