Celexon Electric Professional 사용 설명서 - 페이지 3

{카테고리_이름} Celexon Electric Professional에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Celexon Electric Professional 11 페이지.
Celexon Electric Professional에 대해서도 마찬가지입니다: 사용 설명서 (8 페이지)

페이지 인쇄

•

Suspended loads must be checked for strength and load-bearing capacity at least

twice a year.

•

Children should not use the screen or play under it unsupervised.

•

Caution: Risk of injury! The unit closes flush and firmly in its retracted state, keep

fingers, hands or other small parts away from the opening.

•

All supply lines and cables must not be subjected to additional loads and must be

laid in such a way that they are not damaged or crushed.

•

Failure to observe the above instructions may result in personal injury and damage

to the product or equipment connected to it. Incorrect installation or use may also

invalidate the warranty.

•

If you are unsure about the use of the product, please contact specialist personnel,

your dealer or celexon directly (Web: www.celexon.co.uk, Mail: [email protected]).

•

Technical changes and errors expected.

The manufacturer accepts no responsibility for damage to property or personal injury,

if the screen is used outside the recommended specifications, or in the event of

improper installation. Do not use this screen in the vicinity of heaters or air conditioners.

Also, do not mount the product in direct sunlight or in front of a window. Due to the

temperature-sensitive PVC surface, the projection screen fabric may be permanently

damaged.

We recommend that you wait approx. 2 hours after delivery before installing the

projection screen. This way you will allow the screen to acclimatise, especially when

moving from a cold to a warm environment (or vice versa).

Please avoid any stains on the surface of the screen. These may not be able to be

removed.

The positions of the end points are already optimally set at the factory and should not be

changed. Especially with electric screens, the entire length of the fabric should always be

used in order to achieve the best flatness. An adjustment of a few cm of the end points

should only be made by persons with specialist knowledge and in consultation with the

manufacturer. Incorrect adjustment can result in damage to the projection surface