Automotive Data Solutions FIRSTECH FT-DC3-LC 제품 설명서 - 페이지 11
{카테고리_이름} Automotive Data Solutions FIRSTECH FT-DC3-LC에 대한 제품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Automotive Data Solutions FIRSTECH FT-DC3-LC 12 페이지.
페이지 인쇄
REMOTE STARTER ERROR CODES:
NOTES
I WARNING: The following applies only when the parking
lights are connected and supported by the system.
II After a remote starter failure, the parking lights will fl ash
three [3x] times, then will fl ash [X] number times to
indicate an error code. See table.
REMOTE STARTER SHUTDOWN ERROR CODES:
NOTES
I WARNING: The following applies only when the parking
lights are connected and supported by the system.
II If the engine shuts down after a remote starter sequence:
Press and hold the Trunk button and the Start button at the
same time for 2.5 seconds when using a 1-WAY remote.
OR
Press once [1x] on button "4" when using a 2-WAY remote.
The parking lights will fl ash four [4x] times, then will fl ash
[Y] number times to indicate an error code. See table.
Patent No. US 8,856,780 CA 2759622
Automotive Data Solutions Inc. © 2019
REMOTE STARTER ERROR CODES - 1 OF 1
01
Engine running.
02
Key in ignition at ON position.
03
Door is open.
04
Trunk is open.
05
Foot brake is ON.
06
Hood is open.
07
The reservation is OFF. (Manual transmission only)
08
Tach failure.
09
The vehicle is moving (VSS).
10
System is in Valet Mode.
11
CAN communication failure
12
RS not synchronized. Start vehicle with OEM key for 15 sec before trying a new RS sequence.
13
Bypass problem.
01
Engine tach signal is lost.
02
Emergency brake is lost.
03
Foot brake is ON.
04
Hood is open.
05
Engine RPM limiter is ON.
06
Glow plug timeout error.
07
Vehicle is moving (VSS).
08
N/A
09
N/A
10
Door is open.
11
CAN communication failure during RS sequence.
12
RS not synchronized. Start vehicle with OEM key for 15 sec before trying a new RS sequence.
13
Takeover is not allowed.
14
Shutdown error, board overheat protection.
FT-DC3-LC
PAGE 11 OF 12
• 20190319
www.idatalink.com