DBI SALA 2200425 사용자 지침 - 페이지 10

{카테고리_이름} DBI SALA 2200425에 대한 사용자 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. DBI SALA 2200425 12 페이지.

DBI SALA 2200425 사용자 지침
Step 3. Inspect the in-line energy absorber. Connecting hook must be free of cracks, corrosion, and other damage.
See Step 1. Inspect webbing; material must be free of cuts, abrasions, burns and discoloration. The
webbing should be free of excessive soiling, paint build-up, and rust staining. Check for chemical or heat
damage, indicated by brown, discolored or brittle areas. Check for ultraviolet damage, indicated by
discoloration and splinters and slivers along the web surface. Check for extension of the energy absorbing
device. Return the system for repairs if extended.
Step 4. Inspect system labels. The labels must be present and fully legible. See section 8.0.
IMPORTANT: If this equipment is subjected to the forces of a fall arrest, it must be removed from service and destroyed,
or returned to DBI/SALA for inspection or repair.
5.4 If inspection reveals an unsafe or defective condition, remove unit from service and destroy, or contact DBI/SALA
for possible repair.
IMPORTANT: Only DBI/SALA or parties authorized in writing may make repairs to this equipment.
5.5 USER EQUIPMENT: Inspect harness and energy absorbing lanyard according to manufacturer's instructions.
6.0 MAINTENANCE, SERVICING, STORAGE
6.1 CLEANING AND MAINTENANCE: Clean the horizontal lifeline system with water and a mild detergent. Wipe dry
with a clean, dry cloth and hang to air dry. Do not force dry with heat. An excessive build-up of dirt, paint, etc. may
prevent the system from working properly, and in severe cases, weaken the rope. A lubricant may be applied to the
moving parts of the rope tensioner. Do not allow lubricant to contact the rope tensioner teeth.
6.2 STORAGE: Store this horizontal lifeline system in a clean, dry environment, out of direct sunlight. Avoid areas where
chemical vapors are present. Thoroughly inspect the system after extended storage.
6.3 USER EQUIPMENT: Maintain, service, and store user equipment according to manufacturer's instructions.

7.0 SPECIFICATIONS

7.1 MATERIALS:
Rope Tensioner: Steel, plated
Lifeline Rope: Nylon
Carabiner: Aluminum Alloy
Energy Absorbers: Polyester and Nylon
Snap Hooks: Alloy steel, plated
8.0 LABELING
8.1 These labels must be present and fully legible:
Vacuum Anchor
Warning Label
Vacuum Anchor
Clearance Label
10