Automotive Data Solutions iDatastart TR2310AR 소유자 매뉴얼 - 페이지 4

{카테고리_이름} Automotive Data Solutions iDatastart TR2310AR에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Automotive Data Solutions iDatastart TR2310AR 12 페이지.

ENGINE STOP

COMMAND

BUTTON

DESCRIPTION

CONFIRMATION

PROGRAMMING A NEW REMOTE

Are you replacing a lost or damaged remote or simply adding an extra remote to your iDatastart system?

Please take note of the following:

1. A functional iDatastart system must already be installed in your vehicle.

2. All new remotes must be installed by an iDatastart Authorized Dealer.

3. A maximum of 4 remotes can be programmed to your iDatastart system.

Follow the steps below to replace the batteries in your iDatastart remotes*.

1. Insert a 25 cent coin into the hollow corner of your iDatastart remote.

2. Gently twist the coin until the casing pops open.

3. Use your coin to pry open the rest of the case perimeter.

4. Carefully remove the circuit board from the case.

5. Slide the old battery out of its enclosure and replace with the new battery.

6. Carefully replace the circuit board into bottom half of the casing.

7. Snap top and bottom casings back together using your hands.

Engine Stop

Stops the engine.

3 chimes + 3 ﬂashes

TR2310AR